Draw a circle with radius \(3.4\ cm.\) Draw a chord \(MN\) of length \(5.7\ cm\) in it. construct tangents at point \(M\) and \(N\) to the circle.
MAH STATE BOARD Mah SB Class 10 Maths · Geometric Contructions
MAH STATE BOARD Mah SB Class 10 Maths · Geometric Contructions
Imagine a bicycle wheel. The spokes go from the centre to the edge. A tangent is like a flat road that just touches the wheel at one point. The road always sits at a perfect right angle to the spoke at that touching point. Here, we draw a circle of radius \( 3.4\ cm \), pick two points on it with a gap of \( 5.7\ cm \) between them, and place a flat line at each point, perfectly square to its own spoke. That is the whole idea.
Answer: The required construction is complete: a circle of radius \( 3.4\ cm \) with chord \( MN = 5.7\ cm \), and tangents drawn at \( M \) and \( N \) each perpendicular to the corresponding radius \( OM \) and \( ON \).
A tangent to a circle is a straight line that touches the circle at exactly one point, called the point of contact. The most important property used in this construction is: the tangent at any point on a circle is perpendicular to the radius drawn at that point. So, to construct a tangent at a given point on a circle, we first draw the radius to that point, and then draw a line perpendicular to that radius at the point. In this problem, we need to construct tangents at both endpoints \( M \) and \( N \) of a chord of length \( 5.7\ cm \) in a circle of radius \( 3.4\ cm \).
Tangent \( \perp \) Radius at the point of contact.
The required construction is complete: a circle of radius \( 3.4\ cm \) with chord \( MN = 5.7\ cm \), and tangents drawn at \( M \) and \( N \) each perpendicular to the corresponding radius \( OM \) and \( ON \).
A common mistake is drawing the tangent perpendicular to the chord \( MN \) instead of perpendicular to the radius \( OM \) (or \( ON \)). Remember, the tangent must be perpendicular to the radius at the point of contact, not to the chord.
The required construction is complete: a circle of radius \( 3.4\ cm \) with chord \( MN = 5.7\ cm \), and tangents drawn at \( M \) and \( N \) each perpendicular to the corresponding radius \( OM \) and \( ON \).
One common mistake: students sometimes draw the tangent at a point as a line through that point making any convenient angle, forgetting that the tangent must be strictly perpendicular (at exactly \( 90^\circ \)) to the radius at that point — always construct the perpendicular properly rather than drawing it freehand.
Answer: The required construction is complete: a circle of radius \( 3.4\ cm \) with chord \( MN = 5.7\ cm \), and tangents drawn at \( M \) and \( N \) each perpendicular to the corresponding radius \( OM \) and \( ON \).
Question: Draw a circle with radius \( 4.2 \) cm. Draw a chord \( PQ \) of length \( 6.4 \) cm in it. Construct tangents at points \( P \) and \( Q \) to the circle. Write the steps of construction.
Solution: Steps of Construction: 1. Draw a circle with center \( O \) and radius \( 4.2 \) cm using a compass. 2. Draw a chord \( PQ \) of length \( 6.4 \) cm inside the circle. (Mark a point \( P \) on the circle, then with \( P \) as center and radius \( 6.4 \) cm, mark point \( Q \) on the circle.) 3. Join \( O \) to \( P \) and \( O \) to \( Q \), drawing radii \( OP \) and \( OQ \). 4. At point \( P \), construct a perpendicular to \( OP \): extend \( OP \) to a point \( P' \) beyond \( P \), then draw the perpendicular bisector of \( PP' \) at \( P \). This perpendicular line is the tangent \( t_1 \) at \( P \). 5. At point \( Q \), construct a perpendicular to \( OQ \) in the same way: extend \( OQ \) to \( Q' \), then draw the perpendicular bisector at \( Q \). This perpendicular line is the tangent \( t_2 \) at \( Q \). 6. The lines \( t_1 \) and \( t_2 \) are the required tangents at \( P \) and \( Q \) respectively. \nVerification: Since \( OP \perp t_1 \) and \( OQ \perp t_2 \), each tangent is perpendicular to the radius at the point of contact, satisfying the tangent condition. \nNote on chord validity: Check that \( PQ \le 2r \), i.e., \( 6.4 \le 2 \times 4.2 = 8.4 \) cm. Since \( 6.4 < 8.4 \), the chord is valid.
Answer: Tangents \( t_1 \) and \( t_2 \) are constructed at points \( P \) and \( Q \) respectively, each perpendicular to the corresponding radius \( OP \) and \( OQ \) of the circle with radius \( 4.2 \) cm.
Question: Draw a circle with radius \( 3.8 \) cm. Mark a chord \( AB \) of length \( 5.2 \) cm in the circle. Construct tangents at the endpoints \( A \) and \( B \). Also verify that the two tangents are not parallel (i.e., they intersect at a point outside the circle when extended).
Solution: Steps of Construction: 1. Draw a circle with center \( O \) and radius \( r = 3.8 \) cm. 2. Mark point \( A \) on the circle. With \( A \) as center and radius \( 5.2 \) cm, mark the intersection point \( B \) on the circle, giving chord \( AB = 5.2 \) cm. \nCheck validity: \( AB = 5.2 \) cm \( < 2 \times 3.8 = 7.6 \) cm, so the chord is valid. 3. Join \( OA \) and \( OB \) (the two radii). 4. At point \( A \): Draw an arc on either side of \( A \) along line \( OA \). Using these arcs, construct the perpendicular to \( OA \) at \( A \). Label this tangent line \( l_1 \). 5. At point \( B \): Similarly, construct the perpendicular to \( OB \) at \( B \). Label this tangent line \( l_2 \). 6. The lines \( l_1 \) and \( l_2 \) are the required tangents at \( A \) and \( B \). \nVerification — Are the tangents parallel? \nThe tangents at \( A \) and \( B \) are perpendicular to \( OA \) and \( OB \) respectively. The two tangents would be parallel only if \( OA \) and \( OB \) are parallel, which happens only when \( A \) and \( B \) are endpoints of a diameter (i.e., \( AB = 2r \)). \nHere, \( AB = 5.2 \) cm and \( 2r = 7.6 \) cm, so \( AB \ne 2r \). \nTherefore, \( OA \) and \( OB \) are not collinear, the angle \( \angle AOB \ne 180^\circ \), and hence the tangents \( l_1 \) and \( l_2 \) are NOT parallel — they will meet at a point outside the circle when extended.
Answer: Tangents \( l_1 \) and \( l_2 \) are constructed at \( A \) and \( B \) respectively. Since \( AB = 5.2 \) cm \( \ne 2r = 7.6 \) cm, the chord is not a diameter, so the two tangents are NOT parallel and intersect at a point outside the circle.
Question: Draw a circle with radius \( 4.2 \) cm. Draw a chord \( PQ \) of length \( 6.4 \) cm in it. Construct tangents to the circle at points \( P \) and \( Q \). Write the steps of construction clearly.
Answer: The construction is complete: a circle of radius \( 4.2 \) cm is drawn with centre \( O \), chord \( PQ = 6.4 \) cm is drawn, and tangents at \( P \) and \( Q \) are constructed perpendicular to radii \( OP \) and \( OQ \) respectively. The two tangents meet (when extended) at a point outside the circle, forming an angle that depends on the central angle \( \angle POQ \).