Which of the following are the nets of a cube\(?\) First, try to answer by visualisation. Then, you may use cutouts and try.
CBSE Class 8 Maths · Exploring Some Geometric Themes
CBSE Class 8 Maths · Exploring Some Geometric Themes
Imagine cutting open a cardboard box and laying it flat on the floor. That flat shape is called a net. A cube has exactly 6 square faces, like the 6 sides of a dice. In figure (vi), there are 4 squares in a row, one square sitting on top, and one square hanging below. When you fold them all up, each square covers one face of the cube perfectly. No square is left out, and no two squares land on the same spot.
Answer: Yes. Figure (vi) is a valid net of a cube. On folding, the row of 4 squares forms the four side faces, while the extra square on top becomes the top face and the extra square below becomes the bottom face, giving a complete cube with no overlap and no gap.
A cube has 6 square faces. A net is a flat (2D) arrangement of these 6 squares that can be folded along the edges to form a closed cube, without any face overlapping and without leaving any gap. So to test a net, we imagine folding the squares upward and check that we get exactly one bottom, four sides, and one top, with each face landing in its own place. In figure (vi), the shape has a horizontal row of 4 squares. One square is attached on top of the row and one square is attached below the row (both near the middle). We fold the row of 4 into the 4 side walls, and the two extra squares become the top and the bottom. When we do this, all 6 faces fit perfectly with no overlap, so this is a valid net of a cube.
A net of a cube must have exactly 6 squares, and on folding it must give: 4 side faces, 1 top face and 1 bottom face, with no overlap and no gap.
Yes. Figure (vi) is a valid net of a cube. On folding, the row of 4 squares forms the four side faces, while the extra square on top becomes the top face and the extra square below becomes the bottom face, giving a complete cube with no overlap and no gap.
A common mistake is to accept any arrangement of 6 squares as a cube net just because it has 6 squares. Having 6 squares is necessary but not enough. The two extra squares must be placed so that one becomes the top and the other the bottom; if both extra squares were on the same side or badly placed, two faces would overlap on folding and it would not form a cube.
Yes. Figure (vi) is a valid net of a cube. On folding, the row of 4 squares forms the four side faces, while the extra square on top becomes the top face and the extra square below becomes the bottom face, giving a complete cube with no overlap and no gap.
One common mistake: students assume that any flat arrangement of 6 squares is automatically a valid net. In reality, the position of each square matters — if two squares end up folding onto the same face of the cube, the arrangement is not a valid net, even though it has the correct count of 6 squares.
Answer: Yes. Figure (vi) is a valid net of a cube. On folding, the row of 4 squares forms the four side faces, while the extra square on top becomes the top face and the extra square below becomes the bottom face, giving a complete cube with no overlap and no gap.
Question: Look at the following two arrangements of 6 squares. Without cutting, decide by visualisation which one is a valid net of a cube, and which is not. Give a reason for each. Arrangement A: A cross-shaped figure — one central square, one square attached to each of its four sides, and one more square attached to the bottom square (forming a plus sign with one extra square hanging below the bottom arm). Arrangement B: A straight horizontal row of all 6 squares placed one after another (a 1 × 6 strip). After deciding, verify your answer by describing how Arrangement A folds.
Solution: First, count the squares in each arrangement. Arrangement A has 6 squares arranged in a cross (plus-sign) shape with one extra square below the bottom arm — this gives exactly 6 squares connected edge-to-edge. Arrangement B has 6 squares in a straight 1 × 6 strip — this also has exactly 6 squares. Now test each by visualisation: Arrangement B (1 × 6 strip): When you fold the strip, the 1st and 6th squares both try to become the top and bottom face, but they end up directly on top of each other, causing overlap. Also, the four middle squares form only a tube — the remaining two squares land on the same face. So Arrangement B is NOT a valid net. Arrangement A (cross with extra lower square): Label the squares as follows — the centre square is C, the top square is T, the left square is L, the right square is R, the bottom square is B1, and the square below B1 is B2. Folding step by step: Square C becomes the base. Fold T upward to become the back face. Fold L upward to become the left face. Fold R upward to become the right face. Fold B1 upward to become the front face. Finally, fold B2 (which was below B1) to become the top face. After folding: Base = C, Top = B2, Front = B1, Back = T, Left = L, Right = R. No two squares overlap and all 6 faces of the cube are covered exactly once. Therefore, Arrangement A IS a valid net of a cube, and Arrangement B is NOT.
Answer: Arrangement A is a valid net of a cube. Arrangement B (1 × 6 strip) is NOT a valid net because opposite faces overlap when folded.
Question: Consider the following two arrangements of 6 unit squares and decide which is a valid net of a cube. Arrangement P: Start with a row of 4 squares placed horizontally (call them squares 1, 2, 3, 4 from left to right). Attach one square above square 2, and one square below square 3. This gives 6 squares in an 'S-like' or 'Z-like' staircase shape. Arrangement Q: A 2 × 3 rectangular block — two rows, each containing 3 squares, placed directly on top of each other. For the arrangement that IS a valid net, describe the folding to confirm it.
Solution: Count squares: Arrangement P: 4 squares in the horizontal row + 1 square above square 2 + 1 square below square 3 = 6 squares total, all connected edge-to-edge. Arrangement Q: 2 rows of 3 squares = 6 squares total, all connected edge-to-edge. Test by visualisation: Arrangement Q (2 × 3 block): The block has only 2 rows. When you fold along the middle horizontal edge, the top row folds directly onto the bottom row — the 3 squares in the top row land exactly on top of the 3 squares in the bottom row. This means every pair of squares overlaps, leaving 4 faces of the cube uncovered. So Arrangement Q is NOT a valid net. Arrangement P (horizontal row of 4 with one square above position 2 and one below position 3): Label: Let the horizontal row be squares 1, 2, 3, 4 (left to right). Square 5 is above square 2. Square 6 is below square 3. Folding: Square 1 (left end) becomes the left face. Square 2 becomes the base. Square 5 (above square 2) folds up to become the top face. Square 3 folds up (away from us) to become the front face. Square 6 (below square 3) folds further to become the bottom face — but wait, square 2 is already the base. Let us reassign. Re-label for clarity: Square 2 is the base. Folding square 1 gives the left face. Folding square 3 gives the front face. Folding square 4 gives the right face. Folding square 5 (above 2) gives the top face. Folding square 6 (below 3): since square 3 is the front face, square 6 hangs below it; when the front face stands up, square 6 folds inward to become the bottom face. Result: Base = square 2, Left = square 1, Front = square 3, Right = square 4, Top = square 5, Bottom = square 6. All 6 faces are distinct and none overlap, so Arrangement P IS a valid net of a cube. Therefore, Arrangement P is a valid net and Arrangement Q is not.
Answer: Arrangement P is a valid net of a cube. Arrangement Q (2 × 3 rectangular block) is NOT a valid net because the two rows fold directly onto each other, causing all faces to overlap.
Question: Consider the following flat arrangement of 6 unit squares joined edge-to-edge: a vertical column of 3 squares (top, middle, bottom), with one square attached to the LEFT of the middle square, one square attached to the RIGHT of the middle square, and one square attached to the LEFT of the top square. By first trying to visualise and then using a cutout if needed, determine whether this arrangement forms a valid net of a cube. Give a reason for your answer.
Answer: Yes, the given arrangement is a valid net of a cube. When M is taken as the bottom face, B folds to become the front face, T the back face, L the left face, R the right face, and X (attached to the left of T) folds up to become the top face — covering all 6 faces with no overlap and no gap.