Answer the following questions based on the frequency polygon given in the adjacent figure.
State the class whose class mark is \(55.\)
MAH STATE BOARD Mah SB Class 10 Maths · Statistics
MAH STATE BOARD Mah SB Class 10 Maths · Statistics
Think of a class mark like the middle point of a ruler segment. Every group of numbers has a midpoint sitting right in the centre. The class mark 55 is the centre of some group. That group stretches 5 units below 55, landing at 50, and 5 units above 55, landing at 60. So the group is 50 to 60. You can check by adding 50 and 60 and halving the result, which gives back 55 exactly.
Answer: The class whose class mark is 55 is 50 – 60.
A frequency polygon is drawn by plotting the class marks (midpoints of class intervals) on the x-axis against the corresponding frequencies on the y-axis. The class mark is the average of the lower and upper limits of a class. From the graph, the classes have a width of 10 (since consecutive class marks differ by 10). So if the class mark is 55, we need to find the class interval whose midpoint is 55.
\[ \text{Class Mark} = \frac{\text{Lower Limit} + \text{Upper Limit}}{2} \]
The class whose class mark is 55 is 50 – 60.
A common mistake is to take the class as 55 – 65 or 45 – 55 by adding/subtracting the full class width instead of half of it. Remember, the class mark is the midpoint, so you must add and subtract half the class width from it.
The class whose class mark is 55 is 50 – 60.
One common mistake: Students sometimes use the difference between the first and last class marks (e.g., 55 – 15 = 40) as the class width, instead of using the difference between two consecutive class marks (e.g., 25 – 15 = 10), leading to completely wrong limits.
Answer: The class whose class mark is 55 is 50 – 60.
Question: A frequency polygon is drawn for a data set with class intervals of equal width 20. One of the class marks visible on the frequency polygon is 70. Identify the class interval whose class mark is 70.
Solution: We use the relation between a class mark and its class interval. The class width is 20, so each class interval spans 20 units. If the class mark is 70, then the lower limit L and upper limit U satisfy: \[ \frac{L + U}{2} = 70 \] So \( L + U = 140 \). Also, the class width gives us: \[ U - L = 20 \] Adding the two equations: \( 2U = 160 \), so \( U = 80 \). Subtracting: \( 2L = 120 \), so \( L = 60 \). Therefore, the class interval is 60 – 80.
Answer: The class whose class mark is 70 is the interval 60 – 80.
Question: A frequency polygon is constructed for grouped data with a uniform class width of 10. One of the plotted points corresponds to a class mark of 45. Which class interval does this point represent?
Solution: We need to find the class interval whose midpoint is 45. Let the lower limit be L and upper limit be U. Using the class mark formula: \[ \frac{L + U}{2} = 45 \] This gives \( L + U = 90 \). Since the class width is 10: \[ U - L = 10 \] Adding both equations: \( 2U = 100 \), so \( U = 50 \). Subtracting: \( 2L = 80 \), so \( L = 40 \). Therefore, the class interval is 40 – 50.
Answer: The class whose class mark is 45 is the interval 40 – 50.
Question: A frequency polygon is drawn for a data set where each class interval has a width of 20. One of the classes has a class mark of 70. Identify the class interval whose class mark is 70.
Answer: The class whose class mark is 70 is 60 – 80.