Detailed Explanation
Each dimple on the golf ball is a small hemispherical hollow (half of a sphere) carved into the surface. To find the surface area of one dimple, we need the curved surface area of a hemisphere, because only the inner curved part of the dimple is exposed on the ball. The flat circular top of the hemisphere is not part of the ball's outer surface — it is the opening on the ball's surface. So we use the curved (lateral) surface area of a hemisphere, which is \( 2\pi r^2 \). Before substituting, we must convert the radius from millimetres to centimetres so units stay consistent.
Formula Used
Curved Surface Area of a hemisphere \( = 2\pi r^2 \)
Solution
- Step 1: Note the given data: Radius of each hemispherical dimple \( r = 2 \) mm. Since 10 mm = 1 cm, we convert: \[ r = 2 \text{ mm} = 0.2 \text{ cm} \] Unit conversion is important because the ball's diameter is given in cm.
- Step 2: Identify the required surface: A dimple is a hemispherical depression on the ball. Only its curved (inner bowl) surface forms part of the ball's exposed area. Hence we need the curved surface area of a hemisphere: \[ \text{CSA} = 2\pi r^2 \]
- Step 3: Substitute the values: Using \( \pi = \dfrac{22}{7} \) and \( r = 0.2 \) cm: \[ \text{CSA} = 2 \times \dfrac{22}{7} \times (0.2)^2 \]
- Step 4: Simplify: First compute \( (0.2)^2 = 0.04 \). \[ \text{CSA} = 2 \times \dfrac{22}{7} \times 0.04 \] \[ \text{CSA} = \dfrac{2 \times 22 \times 0.04}{7} = \dfrac{1.76}{7} \] \[ \text{CSA} \approx 0.2514 \text{ cm}^2 \]
- Step 5: Write the final answer: The surface area of one dimple is approximately \( 0.2514 \) cm\(^2\), which can also be written as \( \dfrac{1.76}{7} \) cm\(^2\).
Final Answer
Surface area of one dimple \( = 2\pi r^2 = \dfrac{1.76}{7} \approx 0.2514 \text{ cm}^2 \).
Common Mistake
A very common mistake is using the total surface area \( 3\pi r^2 \) of a hemisphere instead of just the curved surface area \( 2\pi r^2 \). Since the dimple is a hollow scooped into the ball, its flat circular top is not an exposed surface — only the curved inner part counts. Another mistake is forgetting to convert 2 mm into 0.2 cm before substituting.